Hi Oliver, Probably the best protection for you is your knowledge of the Part 97 rules you professed to know to qualify for your license.
73 ! K0PP On Wed, Nov 7, 2018, 19:06 orbarrett <hoosa...@hotmail.com wrote: > Hi all, > > Several years back there were discussions about how to limit KX3 transmit > capability to the regional ham bands applicable to a KX3 user. As a USA > user, I wanted to revisit this topic to see if my recent firmware (v. 2.76) > allows enforcement of these limits. On page 42 of the KX3 manual, there is > a reference to the BND END message that is supposed to appear if I transmit > out of the ham band in my radio, however it puts out full power in CW mode > (using a dummy load) at 2.5 MHz for example with no displayed message. I > can use the TX Inhibit control line (via the ACC2 connector) to prevent TX, > but would also like software enforcement. > > Could someone please clarify whether ham band TX enforcement is available > for my KX3? > Oliver Barrett KB6BA > > > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to kengk...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com