The KAT500, will do the same for any transceiver - except for following
the receive frequency.
After training the tuner, when the KAT500 receives a burst of RF, it
will tune to the remembered L/C combination for the frequency received,
it will go immediately to that combination.
Train in AUTO mode, then switch to MAN for reliable operation.
73,
Don
W3FPR
On 11/19/2018 6:39 PM, ANDY DURBIN wrote:
"The KAT500 will follow your frequency and change to the pre-set L/C values for that
band and antenna automatically."
Yes that's all wonderful if a K3, or some other means, provides the TX
frequency to the KAT500. The OP does not say he is using a K3 and does not say
that any other frequency interface is being used.
it was my assumption, based on the information in the first post, that RF
sensing is being used and it is not working for the SSB phone signal.
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
