Here’s some things to check: Verify that WSJT-X is pointing to the correct sound devices.
Verify that you do have an audio signal on the lines you expect them to be on. -- Mike Flowers, K6MKF, NCDXC - "It's about DX!" > On Nov 21, 2018, at 8:56 AM, Glenn - N5RN <[email protected]> > wrote: > > Good morning all, > > > > I had this problem show up this morning and haven't figured out what has > changed. > > > > I use a MicroKeyer II (MKII) with the K3. > > > > After working some FT8 DX this morning I went to calling CQ and I noticed > that I wasn't getting any RF output. > > > > The first thing I looked at was the line setting figuring it got bumped and > I just needed to adjust. That wasn't the case. I can't get any RF out > regardless of the setting. > > > > Here's the setup on the K3: > > DATA A > > Mic Sel: Line In > > Mic Setting: varied from 0 to 60 with no effect. > > > > I've tested the setting from within WSJT and everything seem fine. > > > > I have power cycled the MKII, the K3, reinstalled the WSJT-X software > (v1.9.1). I do use a DXLab "bridge" to DXkeeper but that seem to be working > fine. > > > > The K3 goes into TX mode but there is no RF according to the watt meter. > I've tried FT8 on other bands and the same problem. Everything looks right > except there is no RF out. Any suggestions on what to try will be greatly > appreciated. > > > > Glenn > > N5RN > > > > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
