In troubleshooting problems like these, it is helpful to plug
headphones into the sound card audio output jack, to see whether
it's a computer issue or a radio issue.
Dave Hachadorian, K6LL
Yuma, AZ
-----Original Message-----
From: Glenn - N5RN
Sent: Wednesday, November 21, 2018 9:56 AM
To: [email protected]
Subject: [Elecraft] FT8 and K3
Good morning all,
I had this problem show up this morning and haven't figured out
what has
changed.
I use a MicroKeyer II (MKII) with the K3.
After working some FT8 DX this morning I went to calling CQ and I
noticed
that I wasn't getting any RF output.
The first thing I looked at was the line setting figuring it got
bumped and
I just needed to adjust. That wasn't the case. I can't get any
RF out
regardless of the setting.
Here's the setup on the K3:
DATA A
Mic Sel: Line In
Mic Setting: varied from 0 to 60 with no effect.
I've tested the setting from within WSJT and everything seem
fine.
I have power cycled the MKII, the K3, reinstalled the WSJT-X
software
(v1.9.1). I do use a DXLab "bridge" to DXkeeper but that seem to
be working
fine.
The K3 goes into TX mode but there is no RF according to the watt
meter.
I've tried FT8 on other bands and the same problem. Everything
looks right
except there is no RF out. Any suggestions on what to try will
be greatly
appreciated.
Glenn
N5RN
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list:
http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
