If there is an Assembly Manual look into it for assistance. If not, maybe some help in the operators manual?.
Sent from my iPhone ...nr4c. bill > On Jan 19, 2019, at 10:05 AM, Scott Townley <[email protected]> wrote: > > I have a K3/0-mini that I removed the rear bail from. Basically I unscrewed > the four screws, cracked open the case just a bit, and shook all the internal > hardware (nuts/washers) out, and buttoned it back up. > Now I want to put the bail back on. I've gotten the case fully opened up > (two halves), but I'm having a challenge with the PCB that's attached to the > rear half. It appears those four black "nubs" that you can see on the back > are some sort of nylon standoff that's being used for stiffening the PCB. > But it's not obvious to me how to remove them or otherwise disengage them. > Of course I'd prefer to do this without destroying them and leaving four > holes in the back. > Any suggestions? > TIA, > Scott NX7U > > -- > Scott NX7U > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
