Pete I have. KPA500. I can set power out to 100 watts for K3S and amp in Standby. When I switch amp to Operate, I set power to about 20 watts. Next time I switch to Operate the J3S drops to the 20 watt setting. This is a per band setting.
There may be a Config menu setting for this but I’m not sure. Good luck. Sent from my iPhone ...nr4c. bill > On Jan 24, 2019, at 10:01 PM, N4ZR <[email protected]> wrote: > > New owner trying to get ready for the CQWW 160 contest. Rig is a K3 with the > Aux cable connected. When the amp is in Standby mode, using a dummy load, > I'm readily able to deliver 30 watts CW (or 50 or 100) on 160 with the tuner > bypassed or in. However, as soon as I switch the amp to Operate, and send my > first dash, I get a hard fault with the LCD message input power 67 watts. > > I'm guessing it might be a K3 adjustment, but I don't know where to look. Any > advice much appreciated! > > 73, Pete N4ZR > Check out the Reverse Beacon Network > at <http://reversebeacon.net>, now > spotting RTTY activity worldwide. > For spots, please use your favorite > "retail" DX cluster. > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
