If you have a computer printer, print a little strip that says <-NOTCH And tape it in the space on the socket that will be underneath the I.C. and between the pins so the arrow points to where the notch SHOULD be.
Ron (Who me do that?) AC7AC -----Original Message----- Subject: RE: [Elecraft] Help (Question) on building my KX-1 Larry, you are correct that it will make no difference as long as the IC is inserted correctly, but I strongly suggest that you manually notch the other end of the socket (melt the plastic with your soldering iron tip, cut it with a knife, etc.) or put some permanent marking on the socket or board to call attention to this situation a year or two from now when you have forgotten about this error just in case you change the firmware. 73, Don W3FPR > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Larry Wright > Sent: Saturday, June 03, 2006 10:04 PM > To: [email protected] > Subject: [Elecraft] Help (Question) on building my KX-1 > > > I have soldered the 28 pin socket with the notched end toward the > right edge instead of the left edge (Page 18 in the manual). Does this > really make any difference as long as the IC is inserted properly? > > Thanks for any help you can give. > > Larry > N4QY > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
