Sometimes it is even a loose connection - make sure you push the RJ-45 connector all the way in until it clicks. Sounds too stupid but happened to me once...........
73 Roger, DL5RBW -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Thursday, April 18, 2019 4:33 PM To: [email protected] Subject: [Elecraft] P3 Display issues... Hi - I just cannot get this to work for me. I am looking at my P3 connected to a K3. It is connected between the IF In on the P3 and IF Out on the K3. When looking at the P3 display, on all frequencies, I do not see the actual frequency of the VFO, I see 0, for example to top line has -25.0 0 +25.0. On top of that, when I use marker A and move it and press the QSY, nothing happens. What am I doing wrong. The User Guide just says how it should work, but not why it is displaying 0 as center frequency? Thanks, Robin OZ6ABM/5P5R ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
