Hi Robin,
Make sure you have the P3 and K3 connected via the 9 pin RS232 cable, and that
both are at the same baud rate mentioned the manual.
Also, in the P3 menu there is an entry for radio type. Select K3 if it is not
already entered.
73,
Eric
/elecraft.com/
On 4/18/2019 7:32 AM, [email protected] wrote:
Hi -
I just cannot get this to work for me. I am looking at my P3 connected to a K3.
It is connected between the IF In on the P3 and IF Out on the K3. When looking
at the P3 display, on all frequencies, I do not see the actual frequency of the
VFO, I see 0, for example to top line has -25.0 0 +25.0.
On top of that, when I use marker A and move it and press the QSY, nothing
happens. What am I doing wrong. The User Guide just says how it should work,
but not why it is displaying 0 as center frequency?
Thanks,
Robin
OZ6ABM/5P5R
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
