Kieth, I agree with all your ESD comments, but I would hesitate to suggest that anyone do electronics work on a completely conductive surface such as a sheet of aluminum. The possibility of a short to the work surface while testing or working on powered equipment is high. Even with low voltages, the current can be high and therefore dangerous. The surface should be conductive, but not of a low resistance.
Anti-static mats are available that are the size of a computer keyboard and these work fine - it is what I use, and it was not expensive (comparable to the price of a sheet of aluminum). The larger anti-static mats intended for full workbench coverage are quite pricy for hobbists. Google on 'keyboard mat' to find several sources at a reasonable price. 73, Don W3FPR > -----Original Message----- > > I work in an electronics industry and despite all the great reports from > people who said "I build mine on shag carpet and it works fine" ESD > damage is a real issue that causes real problems that don't always show > up immediately. > > ESD protection falls under the category of an ounce of protection. I > happen to have a mat which is where I built my K2. If I did not have a > mat, I'd likely get some sheet aluminum and connect it to a grounded > outlet through a 1 Meg resistor. Use that as your work surface but be > careful not to scratch your rig. > > In either case, get and wear a wrist strap. It is cheap insurance. > > - Keith KD1E - > - K2 5411 - > > -----Original Message----- > Hello, > Any suggestions for a good static free set up to work aside from buying > a mat etc. would be appreciated. > tnx, > Jim/k2hn > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
