This evening I used my new K3S for a normal session of FT8 (K3S
connected to computer via a single USB cable for both CAT control and
audio transfer), then powered it down.
When I powered it up later, the following occurred:
-- It did not display the normal startup message
-- It rapidly switched from DATA to CW mode, remaining there
-- Started beeping a number of times per second, continuing indefinitely
-- Showed "VOX -- OFF" on the display.
Wondering if this could have been caused by unintended pressure on the
CW paddle, I unplugged it but this made no difference. The K3S continues
to go into this state each time I power it down and restart it. I'm
unable to change mode, band, etc.
Any suggestions for resolving this? Thanks in advance.
73,
Frank K6FOD
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
