Call support. Sent from my iPhone ...nr4c. bill
> On Jun 25, 2019, at 12:07 AM, Frank O'Donnell <[email protected]> wrote: > > This evening I used my new K3S for a normal session of FT8 (K3S connected to > computer via a single USB cable for both CAT control and audio transfer), > then powered it down. > > When I powered it up later, the following occurred: > > -- It did not display the normal startup message > > -- It rapidly switched from DATA to CW mode, remaining there > > -- Started beeping a number of times per second, continuing indefinitely > > -- Showed "VOX -- OFF" on the display. > > Wondering if this could have been caused by unintended pressure on the CW > paddle, I unplugged it but this made no difference. The K3S continues to go > into this state each time I power it down and restart it. I'm unable to > change mode, band, etc. > > Any suggestions for resolving this? Thanks in advance. > > 73, > > Frank K6FOD > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
