>From: Dave White <[EMAIL PROTECTED]> >Date: Sun Jun 11 07:30:54 CDT 2006 >To: Elecraft Reflector <[email protected]> >Subject: [Elecraft] OT: Portable Antenna for K2
Hi Dave, Not sure if you can apply this to your application, but I designed the KA3IXF Apartment Antenna, which will be appearing in a upcoming QST Article within the next couple of months. The folks at MFJ and B/W are also looking at it for possible commercial retail application. It is no more than one or two long cardboard tubes wrapped up in electrical tape. You then make or buy a limited space 10 - 40m G5RV and place the feedline in the middle of the tube and then wrap the ends around the tube, leaving about a inch or so between each turn. It looks sort of like a slinky antenna. Then you again wrap the whole thing in electrical tape. I have it sitting outside my apartment on the window sill. With my K2/100, I work DX on a regular basis, on 20m CW. If you can get up to the top floor and place this on a window sill this works well with the K2. Good Luck, Bill KA3IXF >I'm looking to take my K2 (10 watt) on holidays where we will be staying at >a 3-story lodge high atop a bluff overlooking the ocean. The lodge is >surrounded on 3 sides by some tall trees. The roof of the lodge has a table >that I can operate from. I haven't seen the location first-hand, but I >assume I can throw some wire from the roof into the trees. I have a 1 to 1 >balun available and some lengths of "disposable" wire (about 50 - 75 ft) >that I can devote to the project. My K2 has the KAT2 ATU built in. I don't >want to spend any money on this, so a commercial antenna system is out. > >Any ideas on the best configuration to use? Should it be a simple long wire? >Should I use the balun between the radio and the antenna? What about a >ground system? > >Thanks > >Dave White >[EMAIL PROTECTED] > > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
