If setup according to the KAT500 manual (and using the appropriate cables), the
KAT does follow the K3(S) TX frequency.
Wes N7WS
On 8/21/2019 2:17 PM, Andy Durbin wrote:
" All I do is change RX frequency on the K3S and every thing else follows. No RF
required to switch things to the correct configuration for band, frequency and
antenna."
I think that having the KAT500 follow the K3 RX frequency is a really poor
system design. The tuner, and the tuner's frequency dependent antenna
selection, should follow the transceiver transmit frequency. Why does it
matter? Well one day you will transmit with a large difference between TX and
RX frequencies into the wrong antenna and with the wrong tuning solution. This
will fault the KAT500 and/or the KPA500 and could possibly cause damage.
It actually works a lot better if the KAT500 and KPA500 follow the rig TX
frequency and are properly configured before the transmission starts.
73,
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
