If you run in data mode, the TX and RX equalizers are taken out of the loop. No need to reset them.
Joe, KO8V > On Aug 29, 2019, at 09:33, N4ZR <[email protected]> wrote: > > I normally run my K3's TX equalizer to minimize low frequencies and > frequencies above 2000 Hz. Am I right to assume that I should set it back to > flat when doing FT4/8? > > -- > > 73, Pete N4ZR > Check out the Reverse Beacon Network > at <http://reversebeacon.net>, now > spotting RTTY activity worldwide. > For spots, please use your favorite > "retail" DX cluster. > > ______________________________________________________________ ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
