Good afternoon Wes and all, If I connect the antenna directly to the QSR-1, I get the same signal level as the K3s. But, when I connect to the QSR-1 to the IF-out, the signal is about 4 s-units less.
Any ideas...anyone? Fred On Thu, Oct 3, 2019 at 4:14 PM Wes <[email protected]> wrote: > I use an SDR-IQ on the i-f output on my (very) early K3S. it works fine. > IIRC, > always a dubious proposition, I did the mod on my original K3 and it > worked well > too without any additional amplification. I think you have another > problem. > > Wes N7WS > > On 10/3/2019 2:01 PM, Fred Massey wrote: > > Good afternoon, > > > > I have successfully connected my QSR-1 to my K3s if-out, and immediately > > noticed the signal strengths showing on the QSR-1 were much weaker. I > > probably have an early K3s, so the if-out signal strength is even weaker. > > > > Any recommendations at a good preamp to use? It seems like 20db is what > I > > need: > > > > 73, > > Fred > > AE4ED > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
