Thanks all. As always the fine folks on this list came through again!
Up and running now.
Rich
On 11/12/2019 23:38 PM, Don Wilhelm wrote:
Rich,
Online "answers" that are not K3 specific are often incorrect.
You must drive the audio so that you have 4 bars shown on the ALC
mater with the 5th bar flashing. That is the NO ALC point for the
K3/K3S/KX3/KX2.
Once you have achieved that condition, leave the audio level fixed and
adjust the desired power level with the power knob.
There is an article dealing with this subject on my website
www.w3fpr.com.
73,
Don W3FPR
On 11/12/2019 6:47 PM, Rich wrote:
I am at a loss on this one. I have reviewed several online writeups
on the matter but I am still stuck.
I am making these assumptions, the K3s USB port can handle the audio
in/out, rig control and PTT.
I have the following settings.
Audio IN set to K3 audio in USB codec - FT8 decodes fine
Audio OUT set to K3 audio out USB codec - no audio on TX
Rig Ctrl set to COM 10 - rig control is working fine.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
