A few years ago someone posted a method of using a splitter, and the
External Antenna jacks to feed an external SDR with the direct antenna,
not a IF, but a wideband signal from the primary antenna...
I think it was something along the lines of add a splitter, between the
RX Antenna in/out, and then picking off the antenna feed to the SDR from
an output of the splitter... Does this make sense?
Is there a high level block diagram showing the antenna pathing for a
K3, with the ATU installed, and how the front panel switch labeled RX
ANT controls the signal path?
--
73, and thanks,
Dave (NK7Z)
https://www.nk7z.net
ARRL Volunteer Examiner
ARRL Technical Specialist
ARRL Asst. Director, NW Division, Technical Resources
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
