Hola Bob and Jim, I checked all settings, I had not clicked on "Tune". Computer sound settings were all good. Mic and spkr USB both on Audio codex. Changed from Vox to CAT as per Bob's advice.
Still nothing until I changed the 'power slider' in WSJT-x to 100% vs 50. Then got 8 bars....changed to about 70% and got five bars with fifth flickering, although sometimes all five would momentarily blink off for less than one sec, then come back. Also discovered that had to make adjustments to power slider in software whenever I changed bands. K3s Mic gain set at 39,up from original 30 to get proper ALC. Strange, all of this due to update to v 2.1.2. Tnx for all the suggestions, at least back in operation. 73 Tom HP1XT On 2/12/2019 2:24 PM, Jim Rhodes wrote: > And make sure that your operating system has not changed your sound > device settings. Win 10 is bad about that (ask me how I know!) > > On Mon, Dec 2, 2019 at 12:24 PM Bob McGraw K4TAX <rmcg...@blomand.net > <mailto:rmcg...@blomand.net>> wrote: > > Add to my earlier. You may need to adjust levels as previous > version and this one will be different. > > Also suggest you use CAT control and not VOX as CAT is not affected > by audio levels. > > 73 > Bob, K4TAX > > > Sent from my iPhone > > > On Dec 2, 2019, at 11:23 AM, cx...@4email.net > <mailto:cx...@4email.net> wrote: > > > > Hola, > > > > Problem with keying the VOX on the K3s with new install. Select > "Tune", > > it turns red but xmtr does not key VOX. > > > > Never had this problem with v 2.0.0. Double checked USB audio > codex for > > both speaker and microphone. Parameters checked for Radio tab, K3s, > > using usb from KIO3 to computer, com4 (doublechecked Device > manager for > > correct port), VOX tab checked, 38400 and 8-1-none for > Data/stop/handshake. > > > > Line in selected at 30 on K3s along with Vox gain at 30 (same as > > before). K3s mode selected for TX data and Data A menu selected. > > Received and decode FT8 no problem, still no xmit with VOX. > > > > Do not see where I can go back to v2.0.0 as it no longer appears on > > WSJT-x website. > > > > Suggestions? > > 73 > > Tom > > HP1XT > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com