I am not sure if you are trying to power up the P3 with the K3 off, but
........
If you have the P3 powered from the K3 and have the internal jumper set
to power on with K3. Then the P3 will only come on when you power up
the K3.
Just a thought.
Rich
On 12/7/2019 11:13 AM, MaverickNH wrote:
Our downstairs, including my shack, was being remodeled and I just put my
system back together.
The good news:
1. K3S runs and I can RX FT8 on WSJT-X 2.1.2 - CAT works fine
2. Remote ATU works when I hit TUNE on the K3S - SWR read goes to 1.0 (I
have a Directional Coupler/Panadapter TX Sensor 1.8-5.4MHz 2KW installed
too).
3. KAT500 works
The stuff to work on:
1. P3 does not power on by front Power Button push
2. KPA500 does not power on by front ON button push
3. WSJT-X Tune or TX and I hear signal emitting from my PC monitor (which
has an integrated speaker, I guess) - USB Audio Codec selected for both
Input and Output in WSJT-X Audio settings
The power-on issues I cannot figure - cables look OK but maybe not...or a
K3S setting?
WSJT-X sound output issues - maybe Win10 updates and WSJT-X changes to sort?
Bret/N4SRN
--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to rwnewbo...@comcast.net
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
