Are you powering the P3 from the K3S? May have blown an internal fuse
in the K3S 12V aux feed.
KPA500 does not power on. Is the switch on the back ON?
Yes, recent WSJT-X update did change some of the TX audio level values.
You will need to check the SPKR value on your computer, about 30% is
good to start, set the PWR slider on WSJT-X to 1/3 from top for both
TUNE and Transmit. Check to see that DATA A mode is selected on the
radio and the Line Gain {set by the MIC knob} is about 30 or so.
All three audio control points must be correct for things to work
correctly. If any value is near minimum or near maximum then there are
adjustments through the 3 points which need to be made.
Those three points are:
SPKR level on the computer
PWR setting slider in WSJT-X
Line Gain on the K3S.
73
Bob, K4TAX
On 12/7/2019 10:13 AM, MaverickNH wrote:
Our downstairs, including my shack, was being remodeled and I just put my
system back together.
The good news:
1. K3S runs and I can RX FT8 on WSJT-X 2.1.2 - CAT works fine
2. Remote ATU works when I hit TUNE on the K3S - SWR read goes to 1.0 (I
have a Directional Coupler/Panadapter TX Sensor 1.8-5.4MHz 2KW installed
too).
3. KAT500 works
The stuff to work on:
1. P3 does not power on by front Power Button push
2. KPA500 does not power on by front ON button push
3. WSJT-X Tune or TX and I hear signal emitting from my PC monitor (which
has an integrated speaker, I guess) - USB Audio Codec selected for both
Input and Output in WSJT-X Audio settings
The power-on issues I cannot figure - cables look OK but maybe not...or a
K3S setting?
WSJT-X sound output issues - maybe Win10 updates and WSJT-X changes to sort?
Bret/N4SRN
--
Sent from: http://elecraft.365791.n2.nabble.com/
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
