Pete,
Check the Keyout jack with your ohmmeter. One lead to the center
conductor and the other to the shell.
During receive, it should read infinite resistance, and when you go to
transmit, the resistance should go to near zero.
Do you have anything else connected to the KEYOUT jack (an amplifier
perhaps)? If so, you will have to use isolating diodes for the amp and
your relay for the antenna.
73,
Don W3FPR
On 12/27/2019 6:12 PM, N4ZR wrote:
I'm trying to set things up so that I can disconnect my 160M transmit
antenna whenever I'm receiving, to prevent noise coupling into my RX
antenna. My thought is to use the Key Out jack on the K3 to control DC
to a relay at the base of the antenna, floating the base of the
inverted L unless PTT is asserted. The lashup is complete, and works
when I short the phono plug manually, but not when I plug it into the
KEY OUT jack and energize PTT.
I'm hoping it's just a menu issue, but my manual doesn't show any menu
options affecting the Key Out Jack. I have a KPA-1500, and Low Power
Key Out via the ACConnector works fine for controlling the amplifier, so
I assume the basic functionality is OK. Any advice? I'd really love to
get it going for the Stew tomorrow!
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
