My apologies.... I said it was RJ-12.... I believe I remembered
incorrectly.... It's an RJ-25 (straight thru). RJ-12 is a handset
cable with NON-straight thru wiring... essentially reversed to bridge
the handset to the base device.
RJ-25 is a 3-line, straight thru cable. <blush> That'll teach me to
respond from an obviously faulty memory.
______________________
Clay Autery, KY5G
(318) 518-1389
On 01/13/20 16:00, John Altman wrote:
My K-Pod has stopped working ... it works (macros are functional) for a
few minutes after K3S turned on and then power light is out and button
functions do not work! Turn rig off and back on a few minutes later and it
functions, for awhile.
I have reloaded full firmware for both K3S and P3 ... no behavioral change.
I have disconnected K-Pod cable at both rig and K-Pod, re-connect, no
change.
Cable is connected in jack under front panel.
Otherwise, K3S is fully functional. I am aware the “macros” reside within
the K3S.
Could this be the cable between the rig and K-POD?
Any ideas to remedy this situation will be greatly appreciated. Direct
reply to [email protected].
Thank you,
John WA4AIP
K-LINE Station
ARRL Charter Life Member
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
