Don It’s 38400 baud, not 24800.
Sent from my iPhone ...nr4c. bill > On Feb 17, 2020, at 6:24 PM, Don Wilhelm <[email protected]> wrote: > > There is an RS-232 "dongle" that ships with every K3S. It has an RJ-45 plug > on one end and an RS-232 DE9 connector on the other end. > If you plug it in, change the switch on the KIO3B board (inside the K3S) to > RS-232 and change the RS232 menu entry to 28400 baud, you can use that > connection just like on the K3 - note that you will also use that same > connection for firmware downloads and other K3 Utility operations (i.e. the > USB connection will not be usable). > > 73, > Don W3FPR > >> On 2/17/2020 6:05 PM, W4IEN wrote: >> I have a problem that I am sure some of you have run into. I am trying to >> use my K3S remotely using a K3/0 with the RemoteRig 1258 MKIIs hardware. I >> can get everything set up except for the connection from the RS232 to the >> RS232 on the RemoteRig hardware. The RS232 on the K3S does not have the >> same type of connector as the RemoteRig hardware. Has anyone gotten around >> this problem. Any help would be appreciated. Hope I explained my situation >> well enough so it is understandable. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
