Check the assembly errata. It’s corrected there. Figure 16 is correct.
Grant NQ5T > On Mar 25, 2020, at 9:41 PM, Mike Parkes <[email protected]> wrote: > > Hello team Elecraft > I have some minor dust intrusion into the KX3 behind the bezel and wanted > to remove it and do some light cleaning. Is there anything to be aware of > before removing the VFO knob and the bezel? > > The assembly instructions say: "*Place the bezel on the front panel and > secure it, and the CP board inside, as shown in Figure 14"*. (But figure 14 > shows* "Preparing the Rubber Washer for Mounting on the VFO B Encoder"*... > is this meant to say Fig 16?) Fig 16 shows the bezel in place, I guess the > bezel is being screwed into the CP board? I don't want to start into this > and screw something up! Thanks for any tips if you have any. > > 73's to Mike AB7RU > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
