I am helping a friend upgrade an older K3/100 (s/n 798) after he recently acquired it from estate of a SK. I have brought firmware forward one or two versions and installed the KIO3B board set. The radio has main RX only and the KSYN3A upgrade. It does have the KANT3 antenna tuner.
I ran the 5 watt TX Calibration and it failed due to high swr on 6m only. I thought this curious so ran this test against one of my K3S with the same high quality dummy load and cable. It passed. I also scanned the dummy load with my RigExpert and it is flat to at least 2m. We would appreciate any suggestions as to how to further troubleshoot this issue. My friend says that 6m is not important to him - today - but tomorrow might be a different story. It seems reasonable to us that so long as we are working on it, we should leave it fully operational. I have not looked to see if the front panel to main board pin upgrade or any other hardware mod has been performed. Jim N1NK ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
