Other than using a computer, is there a menu item where the tx calibration values can be seen?
Tha manuals are pretty much assuming that you have a computer and still have the one that you did the calibration on. Chuck Jack Hawley KE9UW Sent from my iPhone, cjack > On Apr 5, 2020, at 7:24 PM, Don Wilhelm <[email protected]> wrote: > > Jim, > > If I am not mistaken, if the K3 Utility TX Gain calibration fails on any > band, no calibration information is stored in the K3. If you do it manually, > it will save on a band by band basis. > > 73, > Don W3FPR > >> On 4/2/2020 9:12 AM, Jim Spears wrote: >> I am helping a friend upgrade an older K3/100 (s/n 798) after he recently >> acquired it from estate of a SK. I have brought firmware forward one or two >> versions and installed the KIO3B board set. The radio has main RX only and >> the KSYN3A upgrade. It does have the KANT3 antenna tuner. > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
