I also tried the 3 sec KHz lock procedure on both vfo's however that did not prevent the sync either.
-----Original Message----- From: Adrian [mailto:[email protected]] Sent: Saturday, 11 April 2020 1:29 PM To: 'Bob McGraw K4TAX' Cc: '[email protected]' Subject: RE: [Elecraft] KX3 WSJTX Split Bob, I still seem to have the same issue with your suggestion, when first TX terminates the frequencies sync. See ; https://youtu.be/PMO_IlYsoe0 Thankyou Adrian , vk4tux -----Original Message----- From: Bob McGraw K4TAX [mailto:[email protected]] Sent: Saturday, 11 April 2020 10:19 AM To: Adrian Subject: Re: [Elecraft] KX3 WSJTX Split Adrian: The way and reason this works, if you have the WSJT-X Split Mode set to RADIO via F2 Setup menu, then the software commands the radio to go into the split mode. The split mode in this sense is to keep the audio transmitted tone above 1500 Hz and moves VFO B in order to do so. This is not the traditional thinking and operation where one uses split when working a DX pileup. If you have the Split Mode set to NONE in the WSJT-X software, then there is no split command sent to the radio. Thus you can manually select SPLIT via the radio and this allows you to receive the frequency of choice on VFO A and then you can transmit on the frequency of choice on VFO B. Sorry I didn't make this clear originally. 73 Bob, K4TAX On 4/10/2020 5:32 PM, Adrian wrote: > Thanks Bob, I will try that out. > > > regards > > > Adrian , vk4tux > > On 11/4/20 8:08 am, Bob McGraw K4TAX wrote: >> In the F2 Setup Menu for WSJT-X change the SPLIT Function to NONE. >> Then set the Radio for SPLIT mode. That way you can manually adjust >> VFO A for RX and then set VFO B for the TX frequency. Just keep >> the audio tone above 1200 Hz for TX. >> >> Resolves the problem >> >> 73 >> >> Bob, K4TAX >> >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
