It sounds like you need to do the frequency calibration as documented on page 39 of the manual <https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf> : https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf
Max NG7M On Fri, Apr 24, 2020 at 7:14 PM Frank O'Donnell <[email protected]> wrote: > Here's what I'm sure is a beginner question. > > If I feed an accurate signal from a waveform generator into my K3S, on > the P3 it appears right about 120 Hz higher than the actual frequency. > This seems to be independent of the mode the K3S is in. What causes that? > > I noticed this when I had my K3S/P3 running while working the ARRL > Frequency Measurement Test with other gear, and was curious about it. > > Thanks much, > > Frank K6FOD > > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] > -- M. George ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
