+1, yup! Mine is spot on, as calibrated... as in less than 1 Hz error rate.
______________________
Clay Autery, KY5G
(318) 518-1389
On 04/24/20 20:27, M. George wrote:
It sounds like you need to do the frequency calibration as documented on
page 39 of the manual
<https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf>
:
https://ftp.elecraft.com/P3/Manuals%20Downloads/E740152%20P3%20Owner's%20man%20Rev%20H1.pdf
Max NG7M
On Fri, Apr 24, 2020 at 7:14 PM Frank O'Donnell <vf...@inkbox.net> wrote:
Here's what I'm sure is a beginner question.
If I feed an accurate signal from a waveform generator into my K3S, on
the P3 it appears right about 120 Hz higher than the actual frequency.
This seems to be independent of the mode the K3S is in. What causes that?
I noticed this when I had my K3S/P3 running while working the ARRL
Frequency Measurement Test with other gear, and was curious about it.
Thanks much,
Frank K6FOD
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to m.matthew.geo...@gmail.com
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to arch...@mail-archive.com
