Here's something that might help. FT8 only decodes in a certain time
slot. Make sure your computer is accessing an NTP server and get the
correct time. Win10 can be set to automatically to access time.nist.gov.
I spent a long time trying to get a ham buddy going the other day and
couldn't figure it out. Another buddy picked up on the fact that time
was not set correctly and he fixed it after which decodes started. I
missed that one. So, just get the correct time and I infer that should
fix your problem. You only need tro be seconds off to not work.
73,
Barry
K3NDM
------ Original Message ------
From: "HP" <[email protected]>
To: [email protected]
Sent: 5/17/2020 7:16:09 AM
Subject: [Elecraft] WSJT FT8 TX not decoded using K3S TX - Rx ok
Afire calling folks on ten who were running as much as +12 on Fri and Sat - and
no answer
I called a friend across town - He sees the signal and it will not decode.
While he was listening
he worked two stations on10 so his setup is working (K3S and Signalink)
I hooked up my K3 - Signalink - and it will not decode the K3S tones -decodes
band signals just fine .
Makes no difference by band 80 or 10 the same and friend same on10 and 15 .
BTW the K3S decodes on air signals just fine.
This apparently happened in past week or so I do more listening than txing .
Last FT8 qsos
in log were 5 /10 .
I uninstalled and re-installed WSJT -latest versions on both the K3 and K3S .
No difference.
I went to earlier K3S config file - no difference.
Did an EEINT and still no difference-two different config files.
Makes no difference 5 watts,20 watts ,50 watts out of K3S. ,or 450 watts out of
KPA . (all into dummy load on both xcvrs.)
Levels out of the computer are essentially same as always both rx and tx . Easy
to get 4 bars ALC
with 5th flickering . Tones in monitor sound clean and looking at the monitor
audio on scope they
are clean sine waves . The monitor signals look essentially the same on both
the K3 and K3S.
Tried looking at recovered audio tones both ways - they look pretty much the
same but hard to tell
dummy load to dummy load because of residual rx noise on the tones. Guess I
could see if I could arrange to get
more signal.
Rig works on CW as always - dd not mess with SSB - Maybe I should look at two
tone tomorrow --
or at least listen to it on SSB.
I restored computer W10Pro 64 bit to several updates ago and no change.
Rebooted computer - restarted programs . Clocks are within a tenth of a second.
I am out of ideas -other than to change the K3S over to using the Signalink
instead of the USB/internal codec.
Guess I will do that later today since its 4 m.
Nuts.
Hank K7HP
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
