The first thing I look at if no decoding is my clock. FT8 requires time be plus/minus 1 second.
You need an app to keep the time. Sent from my iPhone ...nr4c. bill > On May 17, 2020, at 7:18 AM, HP <pfizenma...@q.com> wrote: > > Afire calling folks on ten who were running as much as +12 on Fri and Sat - > and no answer > I called a friend across town - He sees the signal and it will not decode. > While he was listening > he worked two stations on10 so his setup is working (K3S and Signalink) > > I hooked up my K3 - Signalink - and it will not decode the K3S tones -decodes > band signals just fine . > Makes no difference by band 80 or 10 the same and friend same on10 and 15 . > BTW the K3S decodes on air signals just fine. > > This apparently happened in past week or so I do more listening than txing . > Last FT8 qsos > in log were 5 /10 . > > I uninstalled and re-installed WSJT -latest versions on both the K3 and K3S . > No difference. > > I went to earlier K3S config file - no difference. > > Did an EEINT and still no difference-two different config files. > > Makes no difference 5 watts,20 watts ,50 watts out of K3S. ,or 450 watts out > of KPA . (all into dummy load on both xcvrs.) > > Levels out of the computer are essentially same as always both rx and tx . > Easy to get 4 bars ALC > with 5th flickering . Tones in monitor sound clean and looking at the monitor > audio on scope they > are clean sine waves . The monitor signals look essentially the same on both > the K3 and K3S. > > Tried looking at recovered audio tones both ways - they look pretty much the > same but hard to tell > dummy load to dummy load because of residual rx noise on the tones. Guess I > could see if I could arrange to get > more signal. > > Rig works on CW as always - dd not mess with SSB - Maybe I should look at two > tone tomorrow -- > or at least listen to it on SSB. > > I restored computer W10Pro 64 bit to several updates ago and no change. > Rebooted computer - restarted programs . Clocks are within a tenth of a > second. > > I am out of ideas -other than to change the K3S over to using the Signalink > instead of the USB/internal codec. > Guess I will do that later today since its 4 m. > Nuts. > > > Hank K7HP > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to n...@widomaker.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com
