Hi All,
I am going to sell a K1-4 (4 band 40, 30, 20, 15) for the estate of my Elmer. In testing the radio I found 40 meters is about 15dB less sensitivity than 30 and power out about 75 mW. I have double checked the values of components on the filter board to ensure they are correct and installed correctly. I also checked T3 and T4 which can cause issues on 40. T3 has 23 turns on the secondary with three turns on the primary. T4 has 24 turns on secondary and two turns on primary. Another symptom is the CH trimmer cap seems to be at one end of tuning range (not seeing double peak). Note - the radio does not have the ATU option and 30 meters is set for 10.1 MHz and not 10.0 (double checked crystals). >From what I can measure so far the relays seem to be working "as designed". When I switch from 15 meters to 40 meters I can see the pulses to the relays to switch them (latching relays. I did notice in the 4 band filter manual it says K6 relay is not active on 40 but I do see it active and looking at the schematic K6 switches between 15/20 operation and 30/40 so I think there is a typo in the filter board manual at the bottom of page 23. I am using a Marconi service monitor for testing. I have not built an RF probe yet and hoping someone has seen this symptom before. I would like to get the K1 fully operational as the proceeds are going to my Elmer's widow 100% Thanks for reading! Dave wo2x ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
