Mine did. If you tell wsjt to use split it will set it. Sent from my iPhone ...nr4c. bill
> On May 21, 2020, at 9:00 AM, Will Hrachovina K4MI <[email protected]> wrote: > > In order to operate split with data modes, both VFO A and B must be in > ‘Data’ mode. The quickest way to make this happen is to hit the ‘A=B’ button > which would set both to the same frequency and mode. Then WSJT should work in > split mode. > > Not sure why WSJT doesn’t automatically do this, but it may be a difference > from the K3 to the KX3. > > Will Hrachovina > K4MI > Sent from my iPhone for Verizon > >> Previous message follows: >> KX3 + KXPA 100 + PX3 (upgraded to latest firmware) >> >> >> >> Mode: DATA A >> >> Band: Any >> >> >> >> In WSJT-X I enabled Rig Split operation. Running FT8 mode. >> >> >> >> At the beginning of every transmit I briefly see "SPL N/A" >> >> Not sure why or what it means. >> >> >> >> I made QSOs, previously I used Split Operation "Non" and "Fake It" settings >> and they work just fine. >> >> >> >> Any explanation of "SPL N/A" appreciated - RTFM does not yield any answers >> unless I missed something. >> >> >> >> 73 de k1jbd >> >> Bammi > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
