I think this only works if there is an ATU. Sent from my iPhone ...nr4c. bill
> On May 28, 2020, at 11:37 AM, Gareth M5KVK <[email protected]> wrote: > > Thanks Mark > Sadly, Changing the CONFIG KRX3 to be ANT=ATU makes no difference. > > Gareth > > On 28/05/2020, 16:08, "Mark Musick" <[email protected]> wrote: > > HI Gareth, > Sorry, I sent my previous e-mail to you before seeing this one. > You have jogged my memory. > I still believe KRX3 ANT= ATU is correct, but what jogged my memory Gareth > is I believe, and I'll have to check, is that if you have the ATU installed > with the two antenna ports you can use the non-transmit port for a receive > antenna. In other words if you have the ATU and have ANT1 selected as the > transmit antenna you can select ANT2 for receive. It may be that setting is > set to ANT2 when it should be ANT1. However, I believe the K3 is smart enough > to know that ANT1 is the only one available when there is no ATU installed. > > 73, > Mark, WB9CIF > > -----Original Message----- > From: [email protected] <[email protected]> > On Behalf Of Gareth M5KVK > Sent: Thursday, May 28, 2020 14:53 > To: Nr4c <[email protected]> > Cc: [email protected] > Subject: Re: [Elecraft] Problems with KRX3A > > Hi Bill > The documentation around this is a bit confusing, but my understanding is > that this setting defines where the SUB gets its AUX antenna feed from. It > can either be BNC (the Aux RF socket on the back panel), or (if you have the > ATU installed and therefore two ANT sockets) it can get it from whichever ANT > socket is not being used by MAIN. As I do not have ATU installed, the only > option that works is bnc. > > I can choose either MAIN or AUX ant for the SUB by pressing RX ANT > > Does this make sense? > > Gareth, M5KVK > > On 28/05/2020, 14:03, "Nr4c" <[email protected]> wrote: > > Sorry! > > KRX3 Ant=bnc does not agree with both on MAIN. > > Sent from my iPhone > ...nr4c. bill > > >> On May 28, 2020, at 8:54 AM, Gareth M5KVK <[email protected]> wrote: >> >> I spent last evening checking the installation of the KRX3A. I did find one >> bit of incorrect plumbing (in the cables that connect the KRX3A to the rest >> of the K3S): however correcting it made no discernible difference. >> >> The post-installation setup in ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
