Oh, “S” Meter Cal Sorry!
Sent from my iPhone ...nr4c. bill > On Jun 4, 2020, at 4:57 PM, Randy Diddel <k5rhd...@gmail.com> wrote: > > Hello again, > > I sent this message a few days ago but did not get a single response. I have > emailed Elecraft support but due to COVID-19, I am not sure when I will get a > response from them. So here is my message again: > > > Anyone? > > I still have not been able to figure this out. > > 73 > > K5RHD > > /randy > >> On Jun 2, 2020, at 4:42 PM, Randy Diddel <k5rhd...@gmail.com> wrote: >> >> Hi all, >> >> I am trying to do the RF Calibration test using my new XG3. I am getting >> the error below. I have all firmware up to date on the K3s and the XG3. I >> even tried reloading the firmware on the K3s just to see if that worked. Of >> course turning it off and back on again did nothing either. I DO have the >> SUB RX on this rig as well, ideas? >> >> TIA and 73, >> >> K5RHD >> /Randy >> >> >> Elecraft K3 Utility for OS X Revision 1.18.6.28 >> OS X Version 10.15.4 >> K3 MCU revision 05.67. RS-232 speed 38400 bps. >> Turning sub receiver off >> Unlinking VFOs >> Selecting Antenna 1 >> Setting mode to CW >> Turning squelch off >> Turning Preamplifier off >> Turning Attenuator off >> Setting Filter Width to 100 Hertz >> Setting RF Gain to maximum >> Turning CW Tune on >> Writing factory default calibration data >> Writing calibration table to DSP >> Delay 100 ms >> K3 did not respond to DSP command >> !bc20007401350137023802390139033C033A023C033B033D043E053E063D063C083F093C0C3C0D3E0E3D103F0F3C0F400E3F0F3F103E143F1A401F41223F273F2D41333F3E404A4150403B3F113E0244013E003F0041003F003F0140004000400141033D064313412041243F18400B410742033C0442014100EE007451236D5338; >> Power cycle K3 and try calibration again. >> >> >> > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to n...@widomaker.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com