When I check, both show no resistance reading. Shorted probes read -1`or
zero. I am reading from both the holding bolt and a 2D block to the
collector.
The kat2 instructions say to look for greater the 100 ohms and the k2
manual says to check for a short for proper installation. Infinite
resistance meets these criteria but I'm not sure that's a proper
interpretation.
k2 is second hand No. 01112
firmware 2.04
Thanks for any clarification.
Russ
KG7VQ
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
