Hi everyone. I have a very simple question regarding the KX1 assembly instructions. Just before the second visual inspection and "Alignment and Test Part II" and just after the installation of L1 and L2, the instructions say...
"Your kit includes an extra 22k resistor for use at R32. This resistor is not present on the Revision B or B1 PC boards. It must be soldered in place in the location shown below, on the bottom of the board between pins 2 and 3 of U4 (LM386N)." I have Revision B1. I am confused by the line "This resistor is not present on the Revision B or B1 PC boards." Does it mean there is no silkscreen outline for R32, but it must be installed, or does it mean the resistor is not present at all, and should not be used if you have Rev. B or B1? I think it is the former, but I would like to be certain. Thank you in advance. Vin Cortina KR2F K1-4 s/n:1977 KX1 s/n:1476 (under construction) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
