An air-cooled dry dummy load is just fine for 100 W. I like the Oak Hills Research RFL-100 kit. $50 and easy to build. It uses twenty 5 W resistors.
http://www.ohr.com/rfl100.htm I wrote up my build of that kit here. https://observer.wunderwood.org/2016/12/31/building-a-dummy-load/ If you want to buy instead of build, I’d look at one of the used Bird dummy loads listed here. There are other sites, but this one seems to have a good selection. https://www.nm3e.com/loadSampler.htm#LoadSampler wunder K6WRU Walter Underwood CM87wj http://observer.wunderwood.org/ (my blog) > On Jul 1, 2020, at 2:44 PM, NJMike <[email protected]> wrote: > > I need to purchase a dummy load for use with my K2/100. What's the > difference between a dry dummy load and an air cooled dummy load? Which is > better? > > Thanks, > Mike NJ2OM > > > > -- > Sent from: http://elecraft.365791.n2.nabble.com/ > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
