Joe,
Instead of daisy-chaining all the transverters, try connecting only one
at a time (you should be able to use the daisy-chain control cable, but
connect the TX and RX coax directly fron the K2/K3/K3S to the transverter.
Then tell us what the particular problems are with each transveter. We
cannot give much advice on "It just does not work right".
73,
Don W3FPR
On 7/8/2020 8:10 PM, Joseph McIntire wrote:
I have two I need some help with neither one works or ever did. I believe I did
every thing correct and believed something happened in trying to set them up to
do the alignment procedures. But the power indicator came on till I hooked them
up to do the alignment. I really cant see paying shipping and $125 an hour to
get something fixed that cost $369.00 new. But they must be pretty fickle if
one miss step in the setup takes them out. Just hate to see $700. 00 go down
the drain.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
