"I ran the KAT500 Configuration Software, and verified that ANT 3 is configured 
for use on all bands but 6m.  The configuration SW "Operation" tab could not 
select ANT3 either (the K3 was turned off).  "

What was the KAT500 mode when you tried this?  I have observed, and reported, 
that antenna selection does not work properly in BYP.

Can you change any of the antenna enabled/preferred settings?  If so, do they 
persist through a KAT500 power cycle?

No, I have never experienced your EEPROM error and have no suggestions for 
solving that (except for the suggested test).

73,
Andy, k3wyc
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected] 

Reply via email to