The blinking red light is normal. Indicates the onboard processor is working.
Grant NQ5T > On Jul 25, 2020, at 12:48 PM, Michael Gillen via Elecraft > <[email protected]> wrote: > > My P3SVGA board is acting up and there is a blinking red light on the board > (did not notice that before because the lid was always on). > > Is the blinking red light bad? If yes, is there something I can do about it? > > My symptoms are that I am unable to successfully load the FPGAx firmware - it > fails for all FPGA’s with “block 657 write failed”. > > > Thanks guys! > Michael > KK6RWK > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
