Mike,
You are the only one who can determine this. Everyone else is reduced to
guessing because they don't have access to your PSU/K2/power lead.
Simple:
Measure the PSU voltage on RX at the PUS terminals.
Measure the PSU voltage on TX set to 100W at the PSU terminals.
Compare both of these with the internal K2 voltage display.
Report the findings.
Regards,
Mike VP8NO
On 30/06/2020 21:34, Mike Kopacki wrote:
I didn’t have ring connectors big enough but I did have spade connectors. I
crimped and soldered them but there was no change in the voltage readings
during receive and transmit.
Is it possible that the power supply is failing?
Why, if the voltage drops during transmit to 11.6V, does the radio still put
out 100W on 30, 40 and 80 meters?
Thanks,
Mike NJ2OM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
