Steve,
I am not familiar with that particular mic element, but --
If that is a dynamic mic element, no resistor should be used.
If it is an electret type, the normal 5.6k resistor should work fine, it
is not critical - anything between 5.6k and 10k will do fine.
73,
Don W3FPR
On 7/26/2020 7:01 PM, Steve Dyer W1SRD via Elecraft wrote:
Is anyone using this mic element with the K2? If so, what size resistor
did you use between MIC pin 1 and 6?
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
