It’s a electret condenser mike element and requires bias 5.6-10k resister as Don says.
Brian Denley KB1VBF Sent from my iPad > On Jul 26, 2020, at 7:40 PM, Don Wilhelm <[email protected]> wrote: > > Steve, > > I am not familiar with that particular mic element, but -- > > If that is a dynamic mic element, no resistor should be used. > If it is an electret type, the normal 5.6k resistor should work fine, it is > not critical - anything between 5.6k and 10k will do fine. > > 73, > Don W3FPR > >> On 7/26/2020 7:01 PM, Steve Dyer W1SRD via Elecraft wrote: >> Is anyone using this mic element with the K2? If so, what size resistor did >> you use between MIC pin 1 and 6? > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
