That's FB Raj, it's exactly what JP9 is provided to do (See the left column on page 19 of the Transverter Owner's Manual.)
It's also described in Appendix C, Jumper and DIP switch settings. If you have an older manual, you can get the new manual from the Elecraft web site. Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Rajiv Dewan, N2RD Sent: Thursday, July 06, 2006 5:53 AM To: [email protected] Subject: [Elecraft] LO Power for XV transverters I have a full stack of XVs and just migrated to a K2 for IF. Each of the XVs has a crystal oven. I notice in the stock config for K2, the LO power jumper at JP9 is 1-2. (All other jumpers are set as recommended for K2 IF with 0dBm drive and split paths.) Following the schematic it seems to imply that the LO and oven will be on only when the band is selected on the K2. I would prefer to have all the LO and Ovens be on when K2 is on. It seems that I can achieve this by switching the JP9 jumper to 2-3. Is this correct? Any downside to this change? I am running this in my shack to the incremental current draw is not an issue. Any thoughts appreciated, Raj, N2RD K2 #5613 -- Rajiv Dewan, N2RD [EMAIL PROTECTED] FN13fc -- _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
