After a few hours of IARU cw contesting picked up the #3612 again. Ran into a problem with the knobs over the pots on the front panel.
Setting the pots fully clockwise and turning the knob over the shaft and pushing it down gently (as in the manual), one the pots went through the 270 dgs-stop. It is still OK if I check it with a meter and the stops are still there. But.... the knob is not in the right postion yet. It's at the right height obove the frontpanel, but I have to turn the knob a mere 30 degrees to get it in the right position. I hesitate to use more force to turn the knob because this could run the pot past the stop again. Anyone encountered this? What was the solution? 73 Arie PA3A PS : Thanks for the suggestions on the backlight of the display yesterday. Gave good confidence when placing and soldering that component. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
