Hi Gordon - Yes, you can find the command reference here:
https://elecraft.com/pages/kat500-fully-automatic-tuner-manuals As to the KAT500 switching modes, I am not having that problem. I suggest you go thru the Configuration making certain to memorize critical frequencies then run it in Manual mode. 73 Lyn, W0LEN -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Gordon LaPoint Sent: Thursday, September 10, 2020 1:53 PM To: Elecraft Discussion List Subject: [Elecraft] KAT500 Remote software help I'm using the KAT500 with the remote software. Is there any documentation of the command line switches for this software? I have it set to start on bootup, connecting to a specific port at the correct baud rate, it works, but switches the tuner from manual mode to auto mode. How do I prevent this? Gordon - N1MGO ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected] ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
