Lyn,
I have those docs, thanks. I'm looking for the command line
switches for the remote host software. I have the serial port/serial
speed, tcp port and time out. I would like to know if there is any way
to control the mode when the software starts, I know how to change it
after its running, but I don't want to have to switch from "auto" back
to "man" everytime the remote cpu boots.
Thanks,
Gordon - N1MGO
On 9/10/2020 16:24 PM, Lyn Norstad wrote:
Hi Gordon -
Yes, you can find the command reference here:
https://elecraft.com/pages/kat500-fully-automatic-tuner-manuals
As to the KAT500 switching modes, I am not having that problem. I suggest you
go thru the Configuration making certain to memorize critical frequencies then
run it in Manual mode.
73
Lyn, W0LEN
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Gordon LaPoint
Sent: Thursday, September 10, 2020 1:53 PM
To: Elecraft Discussion List
Subject: [Elecraft] KAT500 Remote software help
I'm using the KAT500 with the remote software. Is there any
documentation of the command line switches for this software?
I have it set to start on bootup, connecting to a specific port at the
correct baud rate, it works, but switches the tuner from manual mode to
auto mode.
How do I prevent this?
Gordon - N1MGO
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
