Tom,
You likely have the 6 (or 13) kHz filter enabled for both DATA and AM
modes. Use K3 Utility Filter Calibration to change it.
73,
Don W3FPR
On 10/6/2020 6:25 PM, Tom Azlin W7SUA wrote:
Hi.
My K3 seems to switch to AM around 5 MHz even though the display says
DATA. And the filter highlight on my P3 also switches to the AM width
around tuned freq.
Earlier I had tuned to 5 MHz WWV to do a sound card calibration and
switched mode to AM. Now was trying to test my fldigi FMT Modem against
5 MHz WWV so switched to DATA. Still shows as if I am in AM mode.
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
